ECS TIGT-I2 Spécifications télécharger pdf (Page 14)

Installing the Motherboard

DDR2 SDRAM memory module table

Installing Memory Modules

This motherboard accommodates two memory module. It can support two 240-pin

DDR2 800/667. The total memory capacity is 4 GB.

Do not remove any memory module from its antistatic packaging

until you are ready to install it on the motherboard. Handle the

modules only by their edges. Do not touch the components or metal

parts. Always wear a grounding strap when you handle the modules.

Installation Procedure

Refer to the following to install the memory modules.

1 This motherboard supports unbuffered DDR2 SDRAM .

2 Push the latches on each side of the DIMM slot down.

3 Align the memory module with the slot. The DIMM slots are keyed with

notches and the DIMMs are keyed with cutouts so that they can only be

installed correctly.

4 Check that the cutouts on the DIMM module edge connector match the

notches in the DIMM slot.

5 Install the DIMM module into the slot and press it firmly down until it

seats correctly. The slot latches are levered upwards and latch on to

the edges of the DIMM.

DDR2 667 333 MHz

Memory module

Memory Bus

Installing Hardware

DDR2 800 400 MHz

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Pas de commentaire

ECS TIGT-I2 Spécifications Page 14